After 3 months of use, the Thermicon tips wear off and need to be replaced so that you can make the most of this unique hair removal system. This refill pack gives you an almost 3-month supply of Hot Tips so you can enjoy sleeker, smoother, hair free skin.
What is the no!no! Hair Removal System?
The no!no! Hair Removal System is a state-of-the-art device that makes use of revolutionary new Thermicon technology to reduce hair density by up to 64%. The no!no! emits a gentle wave of heat that painlessly destroys the hair follicle without causing any skin irritation, such as in-grown hairs, red pimples or rashes.
The biggest advantage of the no!no! hair removal device is that you can use the system in the privacy of your home, there’s no need to visit a beautician or undergo any painful treatments. The no!no! Hair Remover works gently on your skin and helps you to remove unwanted hair without discomfort, mess or by using any chemicals. It’s safe to use for all people of all skin types.
What are the Thermicon Tips?
The no!no! Hair Removal System comes with a detachable Thermicon Tip made up of fine patented Thermicon wires. The hot tip transfers heat from the wire to the hair on the skin. A good conductor of heat, the hair passes the heat down into the hair follicle and destroys it. To keep the no!no! Hair Remover functioning perfecting, it’s essential to take good care of the tip and to clean away any of the debris from the burnt hair regularly.
Depending on how often you use the no!no! Hair Remover and your hair type, the Thermicon Tip will last for approximately 2-3 months. It’s recommended that you replace the hot tip as soon as you notice that the device is not functioning as well as before. If the Thermicon wire gets damaged or if the signal light turns red when you use the no!no! Hair Remover, then you may need to change the tip.
This Refill Pack includes 3 short-hair replacement tips to remove hair under 1mm in length and 2 long-hair hot replacement tips for hair over 1mm in length. To get the best results from the device, always use the appropriate Thermicon hot tip.
|
